#Free online astm standards free#
Or view online (only) for free from the American Association of Radon Scientists and Technologists website. This new American National Standard addresses the complexities of properly mitigating radon in large and complicated building structures that require specialized techniques and quality assurance to address complicated building designs and specialized airflow.Ĭopies of RMS-LB 2014 may be purchased from the Association of Radon Scientist and Technologists or from the American National Standards Institute. Radon Mitigation Standards for Schools and Large Buildings (RMS-LB 2014) This new American National Standard addresses the complexities of properly mitigating multifamily dwelling over four units that require specialize techniques and quality assurance.Ĭopies of RMS-MF 2018 may be purchased from the Association of Radon Scientist and Technologists or from the American National Standards Institute. Radon Mitigation Standards for Multifamily Buildings (RMS-MF 2018) Office of Research and Developmentĭownload a copy of the document from NSCEP (TXT, 334 pp)| EPA 625/R-93-011, October 1993 It is intended for use by radon mitigation contractors, building contractors, concerned homeowners, state and local officials and other interested persons. This technical guidance document has been prepared to serve as a comprehensive aid in the detailed selection, design, installation, and operation of indoor radon reduction measures for existing houses based on active soil depressurization techniques.
Or view online (only) for free from the American Association of Radon Scientists and Technologists website. It is applicable to residential structures including: those not more than three (3) stories above-grade in height, those often classified as single-family structures, and those that contain not more than four attached dwelling units on a contiguous foundation.Ĭopies of SGM-SF 2017 may be purchased from the Association of Radon Scientist and Technologists or from the American National Standards Institute. This standard specifies practices, minimum requirements and, general guidance for reducing soil gas entry into existing homes in order to mitigate occupant exposures to certain hazardous soil gases, including radon gas, chemical vapors and other hazardous gases. Soil Gas Mitigation Standards for Existing Homes (SGM-SF 2017).Here are the currently available standards, listed from most recently produced to older standards. Radon measurement and mitigation professionals should identify which standard and/or protocol they are following or comply with, usually determined by the state certification program or national certification program they participate in. One or more of these standards have been recognized or adopted in several ways: first, by various states with radon licensing or certification requirements second, by EPA and third, by national radon proficiency programs, of which there are two, the AARST-National Radon Proficiency Program (AARST-NRPP), and the National Radon Safety Board (NRSB). Standards and protocols for conducting radon measurement and mitigation activities have been available since the early 1990s, and were developed in several ways: first, by EPA with radon industry input second, under the ASTM standards development process and third, by the ANSI-recognized American Association of Radon Scientists and Technologists (AARST) Consortium on National Radon Standards.